Sp-studio-systems SP-12 Manuel d'utilisateur télécharger pdf (Page 12)

GETTING READY

Enhanced by The Emulator Archive 2002 www.emulatorarchive.com

1A SETUP

IMPORTANT!! Before you turn on your SP-12: There is a 115/230 Volt selector

switch on the back of the SP-12, next to the ON/OFF switch. Make sure the AC

voltage indicated on the switch agrees with the AC voltage present in your part of the

world. If not, change the switch settings with a small screwdriver.

1. Set up the SP-12 on a hard surface so that the bottom plate ventilation

holes are not obstructed.

2. Patch a standard, guitar type patch cord between the MIX OUT jack on

the rear panel and a high quality amp or mixing console. The better the

sound system, the more life like the sound of the SP-12.

3. Make sure the ON/OFF switch is in the OFF position. Plug the line cord

into a properly wired three-wire AC outlet.

4. Turn the MIX VOLUME and METRONOME VOLUME controls all the way

to the left.

5. Turn the ON/OFF switch to ON; the SP-12 will run a self-test where all

LED’s will light up briefly to show they’re working properly.

6. Press the RUN/STOP switch (located near the lower right hand corner of

the SP-12) to start the drums, and then turn up the MIX VOLUME control

to hear a demo of what this baby can do. Adjust the monitor system levels

to suit. If you hear the drums, all is well to proceed, press RUN/STOP a

second time and the song will stop.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 98 99

Pas de commentaire

Sp-studio-systems SP-12 Manuel d'utilisateur Page 12